First-Aid Kits for Circuit Boards ®
Newsletter | Ordering | Login
Phone: 978-373-1600
  
Solder Joint Opens - What To Do? More Features
Solder Joint Opens - What To Do?
Non wetted pads due to heavy oxidation.
Electronic components are soldered to circuit boards every day and in some cases opens are found during x-ray inspection or during the test. You may be inclined to re-heat and reflow the solder using a little extra flux. It's reasonable to think this will work but it can be deflating when it is not effective.

In a desperate attempt to correct the defect, the process may be repeated at higher temperatures or for a longer cycle. Yet again, the opens may remain.

While attempts at secondary reflow may often work successfully, it will not work when there are pads with high levels of oxidation. The only way to reliably rework this type of defective solder joint is to remove the component, condition the pads by removing the oxidation followed by tinning, and finally reinstalling the component.

Solder Joint Opens - What To Do?
Partially wetted pads.
Multiple heat cycles not only overheat the components, but also overheat the pads and soldermask, especially when higher lead-free solder temperatures are required. Adjacent components and solder joints can also be impacted negatively.

Damage to component packaging, fractured solder joints, and base board discoloration are some common side effects. It is a perplexing situation. Ask anyone who has pressed down on a component with an open to see it function properly but then when the pressure is removed, the open returns.

The best practice after the first attempt at secondary reflow is to either remove the component and investigate the situation or send the circuit board to a specialist for rework.
Several members of the Circuit Technology Center team contributed to this feature story.
Do Your Repair Techs Deserve One?
Do Your Repair Techs Deserve One?
The Micro-Drill is the ideal tool for precision drilling, grinding and cutting on circuit boards. Use it to remove coatings, cuts circuits, drills holes, and much more.
Learn more ...
Discover 3 Options for BGA Rework
Discover 3 Options for BGA Rework
No matter how much we attempt to streamline and automate the process, BGA Rework has been, and will likely always be, a mixture of art and science.
Learn more ...
Must Have Circuit Boards First-aid Kits
Must Have Circuit Boards First-aid Kits
These kits have been used for decades by the most demanding electronics manufacturers. Every item is thoroughly field tested.
Learn more ...
Stop PCB Scrap Today
Stop PCB Scrap Today
What happens to your valuable circuit boards when they're damaged? Can they be repaired reliably and cost-effectively? Yes, if you have the skills and knowhow.
Learn more ...
ipc-logo Circuit Technology Center has been an IPC member since 1986
Circuit Technology Center Logo
Surgeon grade rework and repair,
by the book and guaranteed. ®