4.0 Conductor Procedures

4.1.1 Lifted Conductor Repair, Epoxy
Covers how to rebond a lifted conductor using liquid epoxy.

4.1.2 Lifted Conductor Repair, Film Adhesive
Covers how to rebond a lifted conductor using film adhesive.

4.2.1 Conductor Repair, Foil Jumper
Covers how to repair a damaged conductor using a foil jumper.

4.2.2 Conductor Repair, Foil Jumper
Covers how to repair a damaged conductor using a foil jumper and film adhesive.

4.2.3 Conductor Repair, Welding
Replace to repair a damaged conductor by welding.

4.2.4 Conductor Repair, Surface Wire
Procedure to repair a damaged conductor using a surface jumper wire.

4.2.5 Conductor Repair, Through Board Wire
Covers how to repair damaged conductors using a jumper wire.

4.2.6 Conductor Repair, Inner Layer
Covers how to repair an inner layer conductor.

4.2.7 Conductor Repair, Surface Plane, Film Adhesive
Covers how to repair a damaged surface conductor plane.

4.3.1 Circuit Cut, Surface Circuits
Covers how to cut surface circuits or conductors.

4.3.2 Circuit Cut, Inner Layer Circuits
Covers how to cut inner layer circuits or conductors.

4.3.3 Deleting Inner Layer Connection at a Plated Hole
Covers how to sever internal connections at a plated through hole.

4.3.4 Deleting Inner Layer Connection at a Plated Hole
Covers how to cut internal connections at a plated hole.

4.4.1 Lifted Land Repair, Epoxy Seal
Covers how to rebond a lifted land using liquid epoxy.

4.4.2 Lifted Land Repair, Film Adhesive
Covers how to rebond a lifted land using film adhesive.

4.5.1 Land Repair, Epoxy
Covers how to replace damaged lands using liquid epoxy.

4.5.2 Land Repair, Film Adhesive
Covers how to repair damaged lands using replacement lands and film adhesive.

4.6.1 Edge Contact Repair, Epoxy
Covers how to repair damaged edge contacts using liquid adhesive.

4.6.2 Edge Contact Repair, Film Adhesive
Covers how to repair damaged edge contacts using new contacts and film adhesive.

4.6.3 Edge Contact Repair, Plating
Covers how to replate damaged or solder contaminated edge contacts.

4.7.1 Surface Mount Pad Repair, Epoxy
Covers how to repair damaged surface mount pads using liquid epoxy.

4.7.2 Surface Mount Pad Repair, Film Adhesive
Covers how to repair damaged pads using new pads and film adhesive.

4.7.3 BGA Pad Repair, Film Adhesive
Procedure to repair damaged BGA pads using new pads and film adhesive.

4.7.4 BGA Pad Repair
Covers how to repair damaged BGA pads using replacement pads and film adhesive.

4.7.5 BGA Pad
Covers how to repair damaged BGA pads using replacement BGA pads and film adhesive.