Printed Board Type: R/F/W/C
Skill Level: Advanced
Conformance Level: High
Revision: E
Revision Date: Jul 7, 2000

Coating Removal Required At Outlined Area

OUTLINE
This peeling removal method for coating can be used only under special circumstances. Normally this method is used to remove RTV silicone or other thick rubbery-like coating materials.

The coating material is removed using a dull knife or otherwise dull blade to slit the coating material and to peel it off the printed board or printed board assembly.

To determine the appropriate coating removal procedure the coating must first be identified. Refer to procedure number 2.3.1.

NOTE
This method is limited to coatings that are rubbery in nature to allow the coating material to be slit into small sections and peeled off the printed board assembly.

ACCEPTABILITY REFERENCES
IPC-A-600 2.0	Externally Observable Characteristics
IPC-A-610 10.0	Laminate Conditions
PROCEDURE REFERENCE
1.0	Foreword
2.1	Handling Electronic Assemblies
2.2	Cleaning
2.3.1	Coating Removal, Identification Of Coatings
2.4.1	Coating Replacement, Solder Mask
2.4.2	Coating Replacement, Conformal Coatings/Encapsulants
IPC7721 3.3	Coating Removal, Peeling Method

Figure 1: Slit and peel off coating using a knife or heated blade.

TOOLS & MATERIALS
Heated Blade or Thermal Parting Tool
Knife
Wood Sticks

PROCEDURE

1. Slit and peel off the coating material with a dull knife or heated dull blade. (See Figure 1).
   
   
2. Repeat as needed until the required material is removed.

EVALUATION

Figure 2: Removal complete.

1. Visual examination or UV light may be used to verify complete removal of coating.