110-6380 Flex-Rack PCB Holder |
INS 110-6380 |
| Qty |
Part No. |
Description |
| 6 |
115-4008 |
Knurled Thumb Screw, 8 mm Long |
| 4 |
115-4025 |
Knurled Thumb Screw, 25 mm Long |
| 4 |
115-4050 |
Leg, 50 mm Long |
| 6 |
115-4060 |
Edge Clamp |
| Pkg 10 |
620-0016 |
Nut, T-Slot, 5 mm Thread |
| 2 |
620-2801 |
Extrusion, 280 mm Long |
| 4 |
620-3001 |
3-Way End Corner Bracket Connector |
| 4 |
620-3020 |
End Cap, 20 mm |
| 2 |
620-3801 |
Extrusion, 380 mm Long |
| 2 |
620-3802 |
Extrusion, 380 mm Long, 2 Clearance Holes |
| 1 |
950-0808 |
Wrench, 8 mm |
| 1 |
950-4605 |
Hex Key, 5/64", 2 mm |
| 10 |
950-5752 |
Washer, Flat, Nylon, .203" ID, .562" OD |
| 2 |
980-2375 |
Name Plate, CircuitMedic |
Fasten the (2) Extrusion, 380 mm Long to the T-Nut in the unit base using the Knurled Thumb Screws, 25 mm long. Place one nylon washer between the aluminum rails and one between the thumb screw and aluminum rail.
Circuit boards can be held by the edges using the Edge Clamp v-grove. Circuit boards may also be placed on the top rim of the Edge Clamps for rapid positioning.
The legs provide a 2-4" (50-100 mm) clearance above preheaters and tool base plates. The heavy-duty aluminum and stainless steel construction ensures the holder is grounded and rigid.
|
